Generic source for air cylinder seals needed

Home| Search | About
User Password
Register Now! Lost Password?

General Metalworking - All aspects of working with metal. 

Bookmark this page:  YahooMyWeb Yahoo!  Google Google  Windows Live Favorites Windows Live  del.icio.us del.icio.us  digg digg  Add to Netscape Netscape
Subject Author Date
Generic source for air cylinder seals needed clutch 04-03-2007
Posted by on April 3, 2007, 3:29 pm
Please log in for more thread options
>I will give that a try if I can't find the ammonium version. I have some
>pipe flux with zinc chloride but it is only 8%.
>
> --
> Glenn Ashmore


Don't forget, you can make your own (much stronger) by killing some
hydrochloric acid with a handful of zinc. (I presume you have zinc lying
around if you're galvanising stuff.) Otherwise use scrap galvanised steel.

Cheers
--
Jeff R.




Posted by Tom Gardner on April 3, 2007, 3:47 pm
Please log in for more thread options
>I will give that a try if I can't find the ammonium version. I have some
>pipe flux with zinc chloride but it is only 8%.
>
> --
> Glenn Ashmore


Don't forget, you can make your own (much stronger) by killing some
hydrochloric acid with a handful of zinc. (I presume you have zinc lying
around if you're galvanising stuff.) Otherwise use scrap galvanised steel.

Cheers
--
Jeff R.




Posted by syoung on April 3, 2007, 5:26 pm
Please log in for more thread options

>I will give that a try if I can't find the ammonium version. I have some
>pipe flux with zinc chloride but it is only 8%.
>
> --
> Glenn Ashmore


Don't forget, you can make your own (much stronger) by killing some
hydrochloric acid with a handful of zinc. (I presume you have zinc lying
around if you're galvanising stuff.) Otherwise use scrap galvanised steel.

Cheers
--
Jeff R.




Posted by on April 3, 2007, 9:41 pm
Please log in for more thread options

>I will give that a try if I can't find the ammonium version. I have some
>pipe flux with zinc chloride but it is only 8%.
>
> --
> Glenn Ashmore


Don't forget, you can make your own (much stronger) by killing some
hydrochloric acid with a handful of zinc. (I presume you have zinc lying
around if you're galvanising stuff.) Otherwise use scrap galvanised steel.

Cheers
--
Jeff R.




Similar ThreadsPosted
Pure Iron source needed (USA) May 9, 2008, 6:50 pm
1 1/16 square section lip seal source needed July 26, 2007, 2:52 pm
Source for loose 3mm ball bearings needed March 20, 2008, 10:35 pm
Small dovetail cutters Source needed. May 21, 2008, 5:24 pm
Source for really small screw extractors needed October 16, 2008, 7:49 pm
Source needed, something equivalent to these Continental Abrasive metal prep disks September 24, 2007, 4:49 pm
Re: anybody got any generic milling or lathe proggys to show off? November 16, 2007, 4:16 am
Re: anybody got any generic milling or lathe proggys to show off? November 18, 2007, 10:27 pm
Seals in oil filter housing. (Last ot post) December 29, 2006, 9:21 pm
high quality mechanical seals March 29, 2007, 9:30 pm

Contact Us | Privacy Policy

XML SitemapXML Sitemap